1.2 แบบห่อ1. ตัดท่อ PVCให้มีความหนา

1.2 style wrap1. PVC pipe cut to a thickness of approximately 10 cm.2. cut the PVC pipe as long U-shaped down approximately 5 cm.3. rubber band around PVC pipes. 4. bring a plastic bag put in PVC pipes.5. bring the pipe aluminium sheet used in PVC. 6. lead sheet aluminium in aluminium-2 pipe end and attach the V-shaped 2-unified by using the nut.7. attach the hoist, with aluminium tubing 2 unified with low aluminium sheet in section 3, about 4 cm.8. drill pipe, aluminum low pulley 4 drill, a pencil.9. drill straight, 2 aluminium tubing ends straight V-shaped hole in the unified fit to bring steel rods.Bracket.10. นำแท่งเหล็กมาเจาะรูตรงปลายด้านเดียว11. นำแท่งเหล็กอีกแท่งมาใส่ในรูของแท่งเหล็กอีกแท่งแล้วนำไปใส่ในรูข้อ 512. นำเชือกมามัดกับรูของแท่งเหล็กในข้อ 6 13. นำเชือกมาใส่ในสปริงขนาดใหญ่14. นำเชือกมาพันกับรอก แล้วสอดลงรูในข้อ 5

1.2 Packing
1. PVC pipe cut to a thickness of about 10 cm
2. Cut the PVC pipe into a U-shaped, about 5 cm long by
3 rubber band around the PVC pipe,
PVC pipe, put in a plastic bag 4.
5. . Remove the cover plate, aluminum bending PVC pipe in the first
6. take two sheets of aluminum on aluminum pipe attached two puppets using a V-shaped nut
7. Remove the pulley attached to the aluminum tube next two shares. low aluminum panels in three approximately four cm
8 holes from low aluminum pulleys in four holes to the size of a pencil
nine. Drill hole 2 inch aluminum pipe straight V-shaped hole fit to put steel
into the bracket
10. Iron rod had pierced a hole in the end only
11. Another leading steel rod into the hole of a steel rod and then be put on the fifth hole
12. Hole of rope tied to a metal bar in the sixth
put the rope 13. Big Spring
14. Wrapped with rope hoists And then inserted into a hole in the fifth.

1.2 wrap.1. Cutting pipe PVC to a thickness of about 10 cm.2. Cutting pipe PVC to a U long down to about 5 cm.3. The rubber strap around the pipe PVC.4. The plastic bag in the pipe PVC.5. The aluminum sheets for bending pipe PVC family in the 1.6. The aluminum sheets in an 2 Martin top striped aluminium pipe 2 share at a V using knot.7. The pulley and stick aluminum tube 2 share By attaching a low aluminium sheet in an 3 about 4 cm.8. Punching aluminium pipe low pulley on an 4 hole to the size of a pencil of wood.9. Punching at the end of the aluminum tube 2 share exactly the form of V hole size fits the iron bars.Based on the inside.10. The steel rods to the hole at the end of one side.11. The iron bar one again put in the pores of the steel rods one again and put in the hole, 512. Bring a rope and tie rods in the hole of 6.13. Lead rope wear in spring large.14. Bring the rope comes with pulleys and insert into the hole in the 5.