การใช้งานต่อกับบอร์ด Arduino การต่อ

Use the Arduino board to plug the Digital I/O, DATA-v Vcc-5, Gnd-Gnd this device uses to communicate with the MCU with the method Single-wire Two-way Serial communication cable is used in this communication as well as data from the MCU and send it to DHT11 and vice versa, but there are temperature and is located 0-50 degrees.

Using Arduino board to connect to the Vcc-5 v, DATA- Digital I / O, Gnd-Gnd device is used to communicate with the MCU of us with Single-wire Two-way Serial communication is used. communication and data transmission over a single cable, either from the MCU to the DHT11 and vice versa either. And the temperature is in the neighborhood of 0-50 degrees.

Use on board Arduino plugging, Vcc-5 V DATA - Digital, I / OGnd-Gnd this device use to communicate with MCU our way Single-wire Two-way Serial communication this will use only a single line of communication cables and the transmission of both. MCU to the DHT11 and vice versa. And area temperature0-50 degrees.