The usual software handshaking cabl

The usual software handshaking cable configuration has 2, 3 crossed & 7 connected straightthrough (with 4&5 jumpered - or used if hardware handshake lines are preferred) and pins 6, 8 &20 jumpered on the control side only. If you choose not to use hardware flow control (RTS/CTS)they must be jumpered at the CNC side. If you have any technical support questions, you call Nexas Tech Support at 905-581-3718. If you get a "MM21 Inconsistent Error", it may be because the REGEN procedure was not donebefore the option was turned on – go back to step 10 and reformat the memory area. Make surethat any part programs and macro programs are backed up of course. Note that the Yasnac will not clear the NC parameters during this upgrade, just the part programmemory. A good backup is always recommended, but unlike other upgrades, this control onlytargets the part program storage area when you add the MX3 board in the MM21 slot. The MX3 board has a special rechargeable Lithium Manganese Di-Oxide (LiMgO2) battery thatbypasses your

The usual handshaking Software Configuration Cable has 2, 3 & 7 crossed Connected Straight
Through (with 4 & 5 jumpered - Hardware handshake or used if Lines are Preferred) and Pins 6, 8 &
20 jumpered only on the Side Control. If You choose not to use Control Hardware flow (RTS / CTS)
they must be jumpered at the CNC Side.
• The Technical Support If You have any questions, You Call Tech Support at 905-581-3718 Nexas.
• The If You Get a ". MM21 inconsistent Error ", it May be because the REGEN procedure was not done
before the Option was turned on - Go Back to Step 10 and reformat the memory Area. Make sure
that any programs and Part Macro programs are backed up of course.
• The Note that the Yasnac Will not Clear the NC Parameters during this Upgrade, just the Part Program
memory. A good Backup is always Recommended, but unlike Other upgrades, this Control only
targets the Part Program Storage Area when You Add the MX3 board in the MM21 slot.
• The The MX3 board has a special rechargeable Lithium Manganese Di-Oxide (LiMgO2) Battery that.
bypasses your

The usual software handshaking cable configuration, has 2 3 crossed & 7 connected straight
through (with 4 & 5 jumpered - or. Used if hardware handshake lines are preferred), and pins 6 8 &
20 jumpered on the control side only. If you choose not. To use hardware flow control (RTS / CTS)
they must be jumpered at the CNC side.
international If you have any technical, support questionsYou call Nexas Tech Support at 905-581-3718.
international If you get a "MM21 Inconsistent Error", it may be because the REGEN procedure. Was not done
before the option was turned on - go back to step 10 and reformat the memory area. Make sure
that any part. Programs and macro programs are backed up of course.
international Note that the Yasnac will not clear the NC parameters during this. Upgrade.Just the part program
memory. A good backup is always recommended but unlike, other upgrades this control, only
targets. The part program storage area when you add the MX3 board in the MM21 slot.
international The MX3 board has a special rechargeable Lithium. Manganese Di-Oxide (LiMgO2) battery that
bypasses your.