Apologies for the delay in this. I’

Apologies for the delay in this. I’m closing in on a solution for the mudguard brackets and am aiming to have the drawing on circulation by the end of today.

I am confident that the dimensions of these parts are OK. Fit-up trials have been successful. However, the datum system was not set up correctly when the inspection was carried out. I think this could account for the errors seen. Could we inspect again to check this? I’ll release the drawing with the part modifications in the mean-time. If the re-inspection still shows some dimensions to be out of tolerance I will then adjust the tolerances on the drawing accordingly in a further up-issue

ผลลัพธ์ (อังกฤษ) 2:

Apologies for the delay in this. I'm Closing in on a Solution for the mudguard brackets and am aiming to have the circulation Drawing on by the End of today. I am Confident that the Dimensions of these Parts are OK. Fit-up trials have been successful. However, the datum system was not set up correctly when the inspection was carried out. I think this could account for the errors seen. Could we inspect again to check this? I'll release the drawing with the part modifications in the mean-time. If the re-inspection still shows some dimensions to be out of tolerance I will then adjust the tolerances on the drawing accordingly in a further up-issue.