comment PSP1 Gland mounting plate ไ

comment PSP1 Gland mounting plate ไม่เพียงพอสำหรับ cable external ตามเอกสารแนบ 12 การติดตั้ง CABLE GLAND จะติดตั้งที่ boxout ด้านล่าง ตามเอกสารแนบ 2 PSP ขอเสนอให้แก้ไขดังนี้1. Move the electrical cables to the same group (internal GIS)2. Drill a 150 x 300 mm hole for (cable external control) as shown in the picture below.

ผลลัพธ์ (อังกฤษ) 1:

comment PSP 1 Gland mounting plate is not sufficient for external cable according to attachment 1. 2 CABLE GLAND installation will be installed at the bottom boxout according to attachment 2. PSP would like to propose the following corrections: 1. Move the electrical cables to the same group (internal GIS) 2. Drill a 150 x 300 mm hole for (cable external control) as shown in the picture below.

ผลลัพธ์ (อังกฤษ) 2:

Comment PSP
1. According to Attachment 1, the outer cable installation plate is insufficient.
2. The installation of cable glands should be installed at the bottom outlet shown in Attachment 2.
PSP suggests modifying as follows:
1. Move the cables to the same group (internal GIS)
2. Drill a 150 x 300 mm hole for external control of the cable, as shown in the following figure.

ผลลัพธ์ (อังกฤษ) 3:

PSP comment
According to Annex 1, Gran loading plate is not enough for external cables.
2 Cablegrand installation will be installed on the following chassis according to Annex 2.

PSP proposes the following amendments:
1. Move cables to the same group (internal GIS)
2. Drill a 150 x 300 hole (external control cable), as shown in the figure below.