1. Regulations in a system's health. And safety related
PR-SR-010: control performance
2. Definition / contraction
No 3. Practice before operation, 3.1
The staff must be trained EHS
3.2 the training content in the control plan performance. To the employee by the superintendent performance
3.3. Practitioners must provide personal protective equipment and inspection equipment, to prevent PPE various to intact before use
3.4 fiber cutting machine must have a card (Guard) cables and other equipment used to test condition. And other equipment intact. The sticker passed state from maintenance. And allow the use 3
.5 block area of operations. And don't the irrelevant in the work
3.6 provided the watcher fire with fire extinguisher operation
3.7 wear equipment. PPE with standard setting (WI-SR-001)
3.8 install partition fireball
3.9 flakes. Layout of cables in rails hang up or hang with hook S made to order
3.10. The workers have no combustible or flammable within that sparks the children to have
3.11 use blanket cover machines and flammable objects. In case may be the sparks from the fiber cutting
3.12 check of leaf cutting number and the lock nut leaves cut the number to tightening
3.13. Switch on-off condition use normal
3.14 do not modify the rock machine cut the number again, such as removing the card fiber cutting machine. A
3.15 should check the leaf fiber used in cutting. The surface cutting must be smooth. If the crack to turn a new leaf
3.16 entering the workpiece to cut. The workpiece must be on that piece. With the capture and lock tightly
3.17. Press down on the surface of fiber cutting blade slowly pressing leaf fiber cutting hard. May cause the cutting crack crack fracture
3.18 no side leaf fiber cutting in decorative pieces It may cause the cutting crack break
3.19 during use if a strange voice. Or a fiber cutting machine trembling. To stop the machine immediately. Because it is a danger signal that leaf cutting number is not balanced, or motor disorders
3.20 before the leaf fiber cutting every time, will turn the switch machine and pull the plug off
3.21. When not working or not in the cut pieces. Will need to unplug the machine cut the number out of the panelboard immediately
3.22 when fiber cutting machine are to stop. Return to the store and repair
3.23 lighting, light enough, in that light is not enough in the corner and dull and in place. It is considered high risk. If necessary, inevitable meeting planning must be thoroughly with the Department Safety
.
การแปล กรุณารอสักครู่..