1.1เมื่อ run progran ซึ่ง channel:a

1.1เมื่อ run progran ซึ่ง channel:ai เชื่อมต่อกับ temperature sensor ซึ่งเป็น analog input จากการสังเกด ในwaveform chart amplitude = 0.271v แต่เมื่อสัมผัสtemperature sensor amplitude เพิ่มขึ้นเรื่อยๆแล้วคงที่ที่ 0.29v
ต่อมาเมื่อsetting the DAQ Assistant Express VI to scale the input signal by C = 100*V ตั้ง range range min = 0 and max = 100พราะอุณหภูมิเป็นlinear ซึ่งเริ่มต้นที่ 0 องศาเซลเซียส เมื่อรันโปรแกรมสังเกตwaveform chart amplitude = 25.7 ํ C ซึ่งเป็นอุณหภูมิภายในห้อง แต่เมื่อสัมผัสกับtemperature sensor waveform chart amplitude = 27.8 ํ C

ผลลัพธ์ (อังกฤษ) 1:

1.1 when the progran channel which run: ai, which is connected to the temperature measuring sensor input from analog waveform amplitude = 0.271 raisins in the chart, but when exposed to temperature sensor v amplitude. Increasingly, and then fixed at 0.29 v Later, when setting the DAQ Assistant Express VI to scale the input signal by setting range C = 100 * V min = 0 max range and youthfulness and a linear temperature = 100, which start at 0 degrees Celsius. When the program runs, notice its amplitude C waveform chart = 25.7, which is the temperature inside the room, but when exposed to temperature sensor waveform amplitude = 27.8 C approved chart.

ผลลัพธ์ (อังกฤษ) 2:

1.1 when run progran which channel: ai temperature sensor, which is connected to the analog input of the property in Szeged waveform chart amplitude = 0.271v but when exposed to temperature sensor amplitude increased and fixed. 0.29v
when setting the DAQ Assistant Express VI to scale the input signal by C = 100 * V set range range min = 0 and max = 100 because the temperature is linear. This starts at 0 degrees Celsius when running the waveform chart amplitude = 25.7 ° C, the temperature inside the room. But when exposed to temperature sensor waveform chart amplitude = 27.8 ° C.

ผลลัพธ์ (อังกฤษ) 3:

1.1 when run progran which channel: AI connected to the temperature sensor which is analog input from under the brigade in waveform chart. Amplitude = 0.271v but when exposed temperature sensor amplitude increased passive and static 0.29v.And it came to pass, when setting the DAQ Assistant Express VI to scale the input signal by C = 100 * V set range range min = 0 and max. = 100 because the temperature is linear which starts at 0 degrees Celsius. When the program runs, observe the waveform chart amplitude = 25.7 C water which is the temperature inside the room. But when in contact with the temperature sensor waveform chart amplitude = 27.8 to C.