1. Put the flowers, flowers, that must be put on hold, the flower in the middle, Roll Log In flower, with flowers, tighten tighten the head, (economically valuable plants), and 3 channels with some force, equally
2.Before you penetrate the steel Center should be used to affix the metal should be done every time before, especially to prevent flower, cut-out or escape does not match the center piece, and should be held firmly with แคล้ มป์
3.How to break into pieces along a very deep so that it does not match the pre-drilled holes at an angle to one side should be used to help a scene against steel, and guidelines on the right to drill the holes in the fronds throughout the scene, the scene does not need to be parallel to that, the flowers.This should be observed, that, parallel to the scene, he
4. The pre-drilled holes, holes in the deep holes should be used as much as in all adhesive or Adhesive tape off a thousand flowers all around, in the distance, measured from the tip to the deep, darts, came in time to penetrate to penetrate the adhesive only
5.For the material to penetrate through the wood or metal scrap material should be used to put a flat on the bottom of the second, penetration, penetration through out fins to prevent debris from the drilling or prevent wood is not simply tear break
6.The drilling holes metal flower should be used, the type of metal can be hosted by view from the label of the flower before drilling holes in Metal should be driven steel take center cut-out every time so as not to flower, slipped out of the position you want to penetrate while Oiling the immigrantUnfortunately, the holes drilled to prevent heat from the drilling and drilling around the slow
7. For the drilling screw holes, knots so that the screw flush with the skin pieces were always nice to do this by the use, through holes drilled in accordance with the head of a screw that is used to tighten the screws down and while the screw head will always fit skin
8.The drill holes in the steel pipe or PVC pipe for pipe holes in the end of the hose should be used near wood lathe circular insert in the tube to the secondary side, the hole is torn in the fins which can be seen from the outside, and then nice
การแปล กรุณารอสักครู่..