ปิ้นล๊อคตำแหน่งไม่ตรงตำแหน่งทำให้th

ปิ้นล๊อคตำแหน่งไม่ตรงตำแหน่งทำให้the return guide หน้าควํ่ามาสำผัสกับ the out shell

Nov 16 During plant stop (HBM Shortage) maintenance team is cleaned (PM) of PLT-402Zs and after finished. then open steam and start running and wait process start and after 2 hrs. (16.30-18.30) recheck it was found the scratch of the outer shell due to the pin locking of the return guide out of the position the resulted the touching of the outer shell
สาเหตุเกิดจากความผิดพลาดเกิดจากหน่วยงาน m ไม่ได้ติดตั้งpinกับคืนตำแหน่งที่ถูกต้อง

ผลลัพธ์ (อังกฤษ) 1:

Pinlok does not directly make the return location guide. But the face comes out with the shellNov 16 During plant stop (HBM Shortage) maintenance team is cleaned (PM) of PLT-402Zs and after finished. then open steam and start running and wait process start and after 2 hrs. (16.30-18.30) recheck it was found the scratch of the outer shell due to the pin locking of the return guide out of the position the resulted the touching of the outer shellReasons caused by the faulty unit not install pin m to restore correct position.

ผลลัพธ์ (อังกฤษ) 2:

Tooting lock position, misaligned, making the return guide page facing into touch with the out Shell

Nov 16 During Plant Stop (HBM Shortage) Maintenance Team is cleaned (PM) of PLT-402Zs and after Finished. Then open. steam and start running and wait process start and after 2 hrs. (16.30-18.30) recheck it was found the scratch of the outer shell due to the pin locking of the return guide out of the position the resulted the touching of the outer shell
causes. caused by the failure of the authorities to return the pin m not installed the correct position.

ผลลัพธ์ (อังกฤษ) 3:

Print position at the position to lock the the return guide page flipped over and was completely taken feel the out shell.Nov 16 During plant stop (HBM Shortage) maintenance team is cleaned (PM) of PLT-402Zs and after finished. Then open steam. And start running and wait process start and after 2 hrs. (16.30-18.30) recheck it was found the scratch of the outer shell. Due to the pin locking of the return guide out of the position the resulted the touching of the outer shell.The error caused by M caused the agency is not installed pin night with proper position.