Starting from the Initialize hard ware. Idle is the condition. Wait for the user to work through key command key or the mouse. Model Selection when the user selects the version of the meter to calibrate the meter to show an image of the model and go back to the Idle State. When the user press the Load File work. An insert loads into the test table, and returns to the Idle State. Run to start calibration and checking of whether the model has been a key series with calibration. The dialog box does not Show the key and return to the alert key, Check Idle end step, if not end the selection range, Send command to Show wave lower & upper tek., Set Wait very Actual spec back to Idle State. but if the Idle State and then back to the finish. When the key value that is read from the calibration parameters after. Press the OK button to Accept value Actual value Comparison Vs. Write data In to Accept tolerance.. and Save data from table table. report file but go Check end. step confirm if Yes, if the Reject Wait to Write data and Save data from table table. report no Clear value file if Wait very Actual. back to Idle State. ON/OFF commands using the Send command ON/OFF output WAVETEK 9105.
การแปล กรุณารอสักครู่..