4-stroke 4-cylinder petrol engine The process works in each stroke of the engine 4-stroke petrol engine. But wat engine lakon The sequential flow throughout the engine is to absorb mechanical wat. The plywood. And evolve your mobile operator to all 4-cylinder range, they were as follows: 1. the rhythm of suction (Suction Stroke.) The vacuum pump from the packaging or an open valve before the piston reaches top dead center slightly until the piston down and pass down the Center in the lower die. Bore will be packaged or cylinder mixed fuel with air during stroke suck. During the Pistons move themselves to a dead center on the back makes the volume of the cylinder and lead to a decrease in pressure as the lowest pressure at about 0.8-0.9 bar, it has suction occurs in dry, followed by the opening of an. Mixed of gasoline and air, it will flow into the pump room. From the work (Working Temperature) temperature of the temperature of the gas, the engine makes a great high I come up to 100° c. At all times the vacuum cylinder Fuel mixture of gasoline and air is pumped into the room is fast because of higher volume expansion in the room. When the Pistons are down there at the lowest pressure difference and lower outside the room. Refers to the diameter of the eco-valve I-d grown as far as possible, a good flowing into the steam room. An open valve before the dead center on approximately 40 degrees to the shaft, but made a message, however, was unable to make good its pumping capacity to substitute for lower pressure is 100% full and the flow of the flow from the well, the more powerful with its short-lived sluggishly. After the dead center below to package pumped to have longer, thus allowing an open valve, an inflow rooms anymore until after the death of approximately 70 degrees to the shaft bottom, Center verses to hurl an close valve. I packed so well at ends
การแปล กรุณารอสักครู่..