1.1เมื่อ run program ซึ่ง channel:a

1.1เมื่อ run program ซึ่ง channel:ai เชื่อมต่อกับ temperature sensor ซึ่งเป็น analog input จากการสังเกด ในwaveform chart amplitude = 0.271v แต่เมื่อ สัมผัส temperature sensor amplitude เพิ่มขึ้นเรื่อยๆแล้วคงที่ที่ 0.29v
ต่อมาเมื่อsetting the DAQ Assistant Express VI to scale the input signal by C = 100*V ตั้ง range min = 0 and max = 100พราะอุณหภูมิเป็นlinear ซึ่งเริ่มต้นที่ 0 องศาเซลเซียส เมื่อรันโปรแกรมสังเกตwaveform chart amplitude = 25.7 ํ C ซึ่งเป็นอุณหภูมิภายในห้อง แต่เมื่อสัมผัสกับtemperature sensor waveform chart amplitude = 27.8 ํ C

ผลลัพธ์ (อังกฤษ) 1:

1.1 when the run program, which connects to the channel temperature sensor: ai which is input from the analog waveform measuring amplitude = 0.271 raisins in chart v, but when exposed to temperature sensor and then increasingly constant amplitude at 0.29 v. Later, when setting the DAQ Assistant Express VI to scale the input signal by C = 100 * V min and max set range = 0 is a linear temperature = 100 youthfulness, which start at 0 degrees Celsius. When the program runs, notice its amplitude C waveform chart = 25.7, which is the temperature inside the room, but when exposed to temperature sensor waveform amplitude = 27.8 C approved chart.

ผลลัพธ์ (อังกฤษ) 2:

1.1 when run program which channel: ai temperature sensor, which is connected to the analog input of the property in Szeged waveform chart amplitude = 0.271v but when exposed to temperature sensor amplitude increased and fixed. 0.29v
when setting the DAQ Assistant Express VI to scale the input signal by C = 100 * V set range min = 0 and max = 100 because the temperature is linear. This starts at 0 degrees Celsius when running the waveform chart amplitude = 25.7 ° C, the temperature inside the room. But when exposed to temperature sensor waveform chart amplitude = 27.8 ° C.

ผลลัพธ์ (อังกฤษ) 3:

1.1 when run program which channel: AI connected to the temperature sensor which is analog input from under the brigade in waveform chart. Amplitude = 0.271v but when exposed temperature sensor amplitude increased passive and static 0.29v.And it came to pass, when setting the DAQ Assistant Express VI to scale the input signal by C = 100 * V set range min = 0 and max = 100 because the temperature is linear. Which starts at 0 degrees Celsius. When the program runs, observe the waveform chart amplitude = 25.7 C water which is the temperature inside the room. But when in contact with the temperature sensor waveform chart amplitude = 27.8 to C.