The device.Table tennis table 1. background to the top of the table is called "surface table" will be a rectangle with a length of 2.74 m (9 ft), width meters (5 feet) of 1.525 and high level must be measured from the surface area up to 76 cm, table height 2 feet 6 inches). 2. the surface of the table, including the top of the table. But not on the side of the table below the top edge of the table.3. the surface of the table may be made with any material, but will be required to have regular rebounds. When you remove a table tennis ball throw down in a high-standard 30 cm Luk is approximately 23 cm rebounds.4. the surface of the table must be dark in color and are NOCs do not reflect light. The top margin of the table surface with the four sides of the white line width 2 cm of 2.74 metres long desk surfaces on both sides is called the "sides" of the table width, 1.525 m surface on both sides called "extracted".5. the surface of the table is divided into two equal partitions with net land which stretched perpendicular to the surface of the table and runs parallel to a line extracted along.6. for a category in each territory is divided into two equal parts by a line of white 3 mm wide by side-line capabilities in parallel with so-called "middle line" and that the central line is part of the core of a desk with a financially.7. international standard competition table tennis table for competition must be used as a brand and type that has been approved by table tennis Federation. Only in the international competition will be required to specify the color of the table to use the competition to the competition regulations.Parts of the net. 1. the components of the Internet. Mesh hanging and pillars, as well as the gripping area with table tennis table,2. the mesh must be stretched taut and anchored by rope to a pole, high tip from the surface table 15.25. Centimeters (6 inches) in diameter and extend from the sides of the desk to the mast against each 15.25 cm (6 inches).In the competition of international Internet standards used for the competition must be a brand and type that has been approved by the international table tennis Federation, and must be the same color table used to race.3. the top of the mesh along the length you want from the surface table 15.25 cm.4. the bottom of the mesh along the length must be aligned with the surface of the table and the end of the mesh on both sides must be aligned with the Poles, as much as possible. Table tennis balls1. There are tongklom and table tennis balls diameter 40 mm table tennis balls must weigh 2.7 ounces.2. table tennis balls used for the competition must be a brand and type that has been approved by the international table tennis Federation, and must identify the color of the ball that will be used in every race in the competition regulations.3. the ball will have to be made with celluloid table tennis, or any other similar plastic material. There are white, yellow, or orange and are NOCs. Wood table tennis 1. the wood table tennis are the shape, size, or weight, however, will have to be flat and rigid crossbow.2. at least 85% of the thickness of the wood must be made with natural wood. The compressor is located next to layer within the crossbow, which to any other material, such as carbon fiber, glass, paper, plywood, or extension, must be safai thickness does not exceed 7.5% of all, thickness 0.35 mm crossbow or real, but no more than most cases, which is less than the. 3. table tennis the crossbow used to hit the ball must have a cover material. The material is the same as an ordinary sheet of rubber granules. By removing the Tablet comes out facing the outside and there is no sponge to accommodate this type of rubber cover, glue, and combined with the crossbow, they must be no more than 2 mm in front of all, or the same type of plate with a rubber sheet sponge support by removing the pellet to turn inside or outside, remove the tablet. This type of tires when the crossbow and combined with glue cover, it must have a thickness of not exceeding 4 mm.3.1) ordinary rubber granules Must be a single piece of sponge to accommodate it, and no rubber or synthetic rubber. There is a Tablet scattered on a regular basis, no less than 10 tablets per 1 square cm and not more than 50 beads per square centimeter.3.2), there kinds of sponge rubber sheet consists of a single piece of sponge off with an ordinary piece of rubber pellet only. Which this ordinary rubber thickness must not exceed 4 mm thickness.4. the material crossbow will need to cover cover cover lateral and Crossbow must not exceed the boundaries of the crossbow go out except for the section near the hilt, and where to place the fingers may be covered or not covered with any material which may be considered to be part of the hilt.5. crossbow table tennis Layers within layers of the material crossbow, and cover the glue must be consistent and have the same thickness throughout the.6. crossbow table tennis one side must be a red light, and the other side must be black. Regardless of whether the crossbow uses table tennis balls to hit, and there must be a color blend is not reflective on a regular basis. Along the edge of a wood, table tennis is not as reflective or colored with a particular part is white.
การแปล กรุณารอสักครู่..