-Release the plastic glass comes with a hole punch or a direct copy glass remove the bottom of the hole, screaming enough to put one into the flashing.-When punching is complete, glass paste were two Plains adjacent to the surfaces (glass and glass bottom edge to each of the side-by-side aligned) and then apply clear tape provided fitted, connected, or may use a Mac instead of sewing. ** Using a Mac would make out shapes are round less than clear tape used. -Transparent tape stuck to it until the circle is a circle, and then we start the second layer.-Let us make the next layer will gradually over the coming one and a half circles, then start making another circle half- When done, the two leading lights flashing when the quarter into the slot hole punch bottom glass. Starting with a circle first and then plug the Chase comes half a second pie I (might be gaps between glass flashing light bulbs quantity tolerance which prepared with not enough.-
การแปล กรุณารอสักครู่..