The device.1. the Ribbon colors2. the coins. 3. scissors1. first, prepare a wide ribbon about 1 * cm. About 8.5 inches long.2. prepare, 4-wire, single or two color, color is used to switch the signature was not that creative ... as you like ... This review uses the portable 2 alternate colors. .. to look at and easier to follow. ..3. fold Ribbon in half, and then capture it. ..4. remove all 4-wire, Ribbon, cross each other.5. pull to tension.6. remove the coins placed in the middle of the Ribbon woven together.7. fold the Ribbon on the right path to override the coins. ..8. fold Ribbon in the lower-right of the first line wraps.9. fold the bottom left line override.10. fold the line on the left, corresponding to the late southern Momma right fold down for the first time. ..11. pull the end of the four-wire, Ribbon, tension ...12. fold Ribbon in half a line on the left side behind the. ..13. folding the ends will have a triangle.14. fold Ribbon in half to the left into compound ...15. the end of the Ribbon and matching storage ...16. the rotation angle, and fold to the right (clockwise) ... We will do the same over and over, all 4 corners ...17. at the end of the Ribbon and matching, and then it dropped out. ... Or you can keep cutting, as you like it.18. the end of the Ribbon, fold it into a triangle like the 12 and 13. 19. Repeat step 14-17 is a triangular fold ribbon cutting in line at the end of the end of the excess off and rotate the angle of the fold to the right. 20. continue, all 4 corners21. Flip pieces of the file back on the back (the other way, upside down to make the other.)22. the end of the Ribbon to fold backwards like the 12 steps. 23. fold the ends down (as step 13).24. fold and conform to the same destination storage steps 14-15 but don't cut the Ribbon ends ...25. match the end of the Ribbon roll. ..26. caught late-coming27. in line at the end of the Ribbon to the right.28. draws the end, tension ...29. work piece rotates to the right (clockwise).30. folding the end of Ribbon-like steps 22-23.31. fold Ribbon in half, and conform to the end (see steps)32. Repeat step 25-2833. pull the end of the Ribbon to my ...34. Repeat until all 4 corner. ..35. ตัดปลายริบบิ้น ..36. ตัดแต่งให้ครบทั้ง 4 ชาย ..37. เสร็จแล้วค่ะ .. ออกมาหน้าตาประมาณนี้ ..38. หรือถ้าไม่ชอบปลายที่เหลือไว้ จะตัดทิ้งให้หมด ก็ได้เช่นกัน39. เทียบด้านหน้า และ ด้านหลัง..40. ภาพสำเร็จออกมาประมาณนี้เลยค่ะ ... สลับสีได้ตามความชอบเลยนะคะ
การแปล กรุณารอสักครู่..