How to use the
step 1 enter the flower, flower, that must be put on hold, the flower in the middle, Roll Log In flower, with flowers, tighten tighten the head, (economically valuable plants), and 3 channels with some force, equally
step 2.Before you penetrate the steel Center should be used to affix the metal should be done every time before, especially to prevent flower punch does not match the location, or escape and center pieces should be held firmly with pliers or unintentional แคล้ มป์
step 3.How to break into pieces along a very deep so that it does not match the holes drilled at an angle to one side should be used steel scene as a way to help out against the drilling holes to match allparallel to it was enough scene
Step 4
flower should be selected to fit the pieces that you want to penetrate
step 5 review, darts, darts, every time before you use it if it is damaged or บิ้น
step 6.Select flowers, suitable for the type of work, such as steel, cement, etc. , or
step 7.The pre-drilled holes, holes in the deep holes should be used as much as in all adhesive or Adhesive tape off a thousand flowers all around, in the distance, measured from the tip to the deep, darts, came in time to penetrate to penetrate the adhesive only
step 8.For the material to penetrate through the wood or metal scrap material should be used to put a flat on the bottom of the second, penetration, penetration through out fins to prevent debris from the drilling or to prevent wood is not simply to tear break
9 steps.The drilling holes metal flower should be used, the type of metal can be cut by view from the label of flowers, before drilling holes in Metal should be driven steel take center cut-out every time so as not to flower, slipped out of position.and use a slow puncture around
Step 10
for the drilling screw holes, undo the screws to always flush with the skin pieces were very nice to do this by using the holes drilled through the picture in accordance with the head screws are used to fasten the screw down, while the screw head will always
skin enough.Step 11
drilling holes in the steel pipe or PVC pipe for pipe holes in the end of the hose should be used in close proximity to machine wood circular insert in the tube to the side of the hole, in a torn fins, which can be seen from the outside, and a nice
12 steps.When you are finished it should work area clean mouth flower handle, to prevent the damage from rust
การแปล กรุณารอสักครู่..