To make a House.To make the House smaller pieces covered with resin to facilitate capture and prepare the pieces in various stages, if the piece is large, it may be convenient to do coat. To make the prison is necessary to complete edge pieces. , For example, want to maintain the thickness of the coating layer and before the prison is supposed to clean the pieces to increase the adhesion between the resin pieces. To make the prison contained 2 are:To make the traditional summer.The first piece of plywood with a high heat lowering, powder curing resin round slices in hot coat. To make this coat is suitable for the work piece does not change the structure of the temperature of approximately 150 C, which is the temperature at the hot-working coat and using a pressure of approximately 4000 psi and a coat this summer with a lot of pieces. Quality of the high building The size and shape of the House, of course, and the short time available to make a House.To make a traditional bayen.As a prison with no pressure and heat is involved. By using a liquid resin mixed with a solid cover to coat pieces. Start by placing the pieces in a way that the plane fell in a cast requires study and then pour the resin mixture, then into the formwork. The term is used about curing 16-24 hours a day to make this coat is ideal for many types of parts and pieces that have just a single piece. In most cases, would be perfect with a piece that is very soft and does not withstand voltage heat team.Preparation of mechanical piecesPrep work pieces based on the contrary removing the surface quality of the work to be required in such a way that the skin shining. Preparation of work pieces divided into 2 stages: noton.The polished plane and polished.Scrub planeAs the first step in tuning the damaged surface and to get a smooth surface with the plane by polishing with coarse sand paper.The conflict resolutionAfter polishing the plane of then to scrub with coarse sand paper to detail each extension of sand paper must be polished to the same direction throughout the work surface and when changing to a more precise number sandpaper polishing, rotate pieces to 90 as shown in the figure, then scrub until Roy lost the original scrub. This is done continuously until 1200 venturi sandpaper.
การแปล กรุณารอสักครู่..