How to use an electric kettle, power-saving. Boiling water, electricity, heating, electrical appliances, the most popular. Hot water is used for tasks such as bathing or using coffee, use clear containers, most of this type of Kettle is a simple plug-in is. Dig the wire will heat until boiling water as needed. How to use energy-saving light, it is. 1. put water, sufficient Put water, fit with your needs because if too much water will cause the waste of time and energy by, Yes, why. 2. unplug immediately when quitting-When boiling water will have to unplug it immediately.-Do not plug in power by the people who do not have, or have forgotten, which save energy and may prevent a fire threatening also. Another type of Kettle will be automated. Known as the "electric hot water bottle" this type of bottle is a device that allows electricity to boil the water, so there is always a virtual kettle and hot water bottle is located on the same computer. While using the electric flow task will flow through the coil and the control of water temperature, the heat in the boiling point increases until the stick after the heat control light will cut off but there are still flowing through the coil currents, but not much. By flowing through the resistor and the hot signal lamp. During this period, it is hot water. When the temperature of the water decreases, until at one point. Set the heat control will work for boiling water again. Electric hot water bottle will work. If they are plugged in. Should pull the power plug out when you don't want to use hot water to save energy. Note: 500-watt electric kettle, open 15 hours per day of electricity per month, amounting to around 6 baht/1300 watt electric kettle, open 15 hours per day of electricity is approximately 16 baht per month.
การแปล กรุณารอสักครู่..