Plate tectonics: each plate is moving in a different direction. The result of the movement to achieve things on the surface world. Both on land and under the ocean, such as mountains. Mount the Hill plateau Valley basin. Volcano The movement of plate tectonics is 3.1. around the plate tectonics are separated from each other (Divergent Boundary) Going straight seam between sheets of crust sheet 2 under the ocean than on the continent, such as the North American plate boundary of Eurasia plate. The two plates are moving separately to achieve thongomhatmuthon and molten rock beneath a crevice that lies deep down to be spurred by a crevice. With cooling and solidifying to become new crust rocks and a ridge. When a splitter plate tectonics Next, you will be molten rock and rock-solid push to the side. The ocean floor, it will flatten out gradually. For this reason, it has a crust that is emerging under the Atlantic at all times and to North America from Europe.2. Roy the crust to move and collide each other (Convergent Boundary) KOEI has 3 forms: 2.1 Earth Ocean plates collide Ocean earth plate and move away from the origin Along the seam where the plate earth-moving out. The pressure from the propulsion cell convection (Convection cell) in asthenosphere. Make a moving Earth two Ocean plates clash. Photo 1: older sill plates Lower temperature and density, rather than sinking down in the address book the deep groove, causing the bottom of the Ocean (Mid oceanic trench) when the earth plate sink it down. Ocean crust and uppermost mantle, which has a low melting point, melting into magma. Which has a density lower than the mantle asthenosphere? Everything floating up causing global surface pressure is a volcanic island arc (Volcanic island arc) arrangement in parallel with horizontal groove depth of the ocean bottom. Among the limestone, which is caused by marine organisms such as corals, there is a sludge of low boiling point of carbon and Hibernate. When it is heated to become carbon dioxide gas. Floating higher relief the crater Causes of turnover and carbon cycle nutrients Examples of volcanic islands that formed by this process are as follows: the islands off the coast of California and Japan Islands papin. 2.2 plates Earth Ocean plates collide with Earth continents. Oceanic basalt sill plates There is greater density of granite, which is the continent sill plates. When the two Earth plates clash. Ocean Earth plates will sink down and melting the magma because magma has a density less than the mantle asthenosphere in it except the crust has forced up into a high mountain range continents. Vertical lined volcano occurred along the shore of the ocean bottom in parallel with a deep groove. photo sample 2 mount the resulting pellets this process allows anonymous: @ nadit mountains along the West coast of South America. 2.3 plates Earth continents collide Plates Earth continents thickness greater than the ocean, earth plate sheet Earth continents clash. One plate is to burrow down into the asthenosphere layer. Another one will be lifted higher KOEI made a very high mountains as paralleled the clash with long shots, for example, the 3 highest mountains formed by this process are: the Himalayas in Nepal in the Alps in Europe.3. the movement of crust sheet joints at each other (Transform Boundary) When the plate tectonics, the movement of both garden make a larger fault occurred and if the plate tectonics move severely affected are the same cause vibrations and earthquakes occurred. But often cannot find a volcano
การแปล กรุณารอสักครู่..