This project is intended to create, and the efficiency of the automatic straw extruder. To reduce the labor of people to cram in the straw straw polls must take a lot of time in developing people, straw bale, as. That this be compressed straw extruder size 40x40 cm long straw, 50, and 100 centimeters. Automatic straw extruder Is a soft straw, which is used to power the motor drive shaft 1 phase in the system, enter the system with compressed straw and straw, the electrical system in a pile, straw, the compressor tank. Compressors, straw can work well. When the straw is no more than 200 grams and weight can also work if there are no more than 300 grams of weight, straw, but the ROK will slow down a little for about 1 second while the ROK is to pile straw. If straw weight 350 gram or more will cause the hoist to run very slowly until it makes a soft straw pile hoists bumped straw pellets, straw and resulted in the system must be stopped. In parts of the compressor system, compressor system, Fang Fang, it was found that the size 50 cm weight 1.9 kg straw bale compression is in a time of 3 minutes, which is a rate of 1.79 to work approximately 16 hours and compressed straw bales/size 100 cm. weight 3.9 kg 3.65 minutes time, which is the rate of work about 33 PCs./hour.
การแปล กรุณารอสักครู่..