Native weaving machine called a loom weaving loom or how many of each there are several components that contribute to each other all while weaving. These components include the following:Some are made of trees long fuem according to the size of the butt of the handle is to be used for a few pulls, push the thrust line cotton fuem condensation as.He has lengthy fuem thonklom made from different kinds of materials, such as plastic or aluminum pipes, bamboo. Their number depends on the number of fuem tako If there are 2 woven fabrics he uses his tako fuem woven fabric with 2 If 4 tako is the 4 him he fuem fuem behind a wooden pedal fuem below using his rope with fuem. That continued with a wooden upper fuem provider. They are intended for switching thread fuem Warp to path to thread sotkrasuai before stamping with fuem.Wooden stomp Tako is made of bamboo or wood, teak, about 2-3 inches size map length of about 2-3 feet, who stepped in as woven-woven cotton line to switch. This wooden pedal at the bottom of the loom When I stepped on the wood and will help raise cotton lines up and down pattern scrub. The amount of wood they will be awarded based on the number of a defined pattern to fuem woven striped pattern which is called tako tako 2 4.Dogtooth wooden fish teeth or the truth, mainly teak-like teeth of a saw sawing si. Used to separate cotton warp not. and easy-to-wipe cotton into the Valley.Wood and wood-HAP HAP fuem Made of teak, bamboo, or lean on big beam of Ki on widely with him and fuem. Using a rope tied to him and to many, tied with fuem strength due to his use of force to pull the fabric up and pull or hammer out fuem horizontally. In the past, after weaving, done on a daily basis. The owner of a fabric portfolio to address during the weaving is weaving loom from the entire series up to the House. To prevent lost clothing from theft using removable devices, all from the loom-woven together as a set on the shoulder, then walked provider in the household, so he called the name of provider. HAP fuemYokohama wheel is a device used for thrust, and the pressure rises to the shuttle, which consists of a wooden rocking up and down, which is attached to the Lever rest upon widely on how many non-rocking side of the seafloor has been stalling 2 wheel?, which is used as a handle for wooden rocking up and down thrust. The next they are woven in accordance.The original wooden birds, because the steel head!! The current use of the hoist, which is easy to find. How to use with each of the birds head 2 left stunning bound to his right, and with two fuem wood fuem top provider relating to wood, wood to reduce pedal is stepped on him one down fuem. The loop of rope through the pulley or the bird heads down with lifted him up another fuem. To make the space between the thread path approach alternate for gushing through the shuttle.Shuttle and stick tube shuttle is a device its penetration in the Middle yaori feature to insert a wooden tube thousands of cotton side-hole drilling. The size is failot. At the end of the shuttle, according to Cape atmon or if the round is used for the Cape heading for a few thrust thrust by hand while the hand-woven fabric manufacturer will shuttle back and forth to provide cotton to prevent rises against the cotton warp wood tube is used for cotton line approach while working to plug in with shuttle. The tubes are made of wood and bamboo bong, which articulate with the thickness and resistance than a typical bamboo. Tight holes through steel to articulate for the slot based on shuttle.Wood reflecting not sharp for finished woven fabrics
การแปล กรุณารอสักครู่..
