1. the problem: write data to a drive that is not valid. Possible causes: check for a drive letter in the State apartments of the path. Workaround: prompt > A: shows that we are working from A drive C: > prompt section shows that we are working from the hard drive. 2. problem: there is not enough space on the ditket sheet ditket sheet ditket or use another exit. Cause: the delete some of the data that is stored on the plate. The solution: be careful not to erase important data stored on floppy ditket by accident. 3. problem: disk drive cannot read sheet ket ditket. Cause: the format is not yet ditket sheet. The solution: hardware, sheet format 4. problem: the computer does not recognize the new devices that are part of the computer. Cause: not your computer configuration after you install a new device. Workaround: If the device is a Plug and Windows will recognize the device and fle set. Configuration, but if this is a non-Plug and play devices, read the documentation that came with your device for information about the configuration. 5. problem: the computer does not recognize the new devices that are part of the computer. Cause: the cable that connects it to the computer, the new device is loose or not plugged into the device. The solution: plug it in, go and check to see that the device is securely attached to the computer. 6. problem: the computer does not recognize the new devices that are part of the computer. Cause: when you make changes to the computer, the recommended value of system configurations. Workaround: shut down the computer, and then open it again. You will see you have not accepted. Those changes.
การแปล กรุณารอสักครู่..