Afterwards, will determine whether or not a list of the last test. If not, the next step by Send a command to a wavetek. Check end step, if not end the selection range, Send command to Show wave lower & upper tek., Set Wait very Actual spec back to Idle State. but if the Idle State and then back to the finish. When the key value that is read from the calibration parameters after. Press the OK button to Accept value Actual value Comparison Vs. Write data In to Accept tolerance.. and Save data from table table. report file but go Check end. step confirm if Yes, if the Reject Wait to Write data and Save data from table table. report No Clear value file if Wait very Actual return to the Idle State. ON/OFF commands using the Send command ON/OFF output WAVETEK 9105.
การแปล กรุณารอสักครู่..