Iron come from? "Audeta" in ancient Thailand. Call appliances nowadays called "iron" and the iron used in the past about 50 years ago Audeta is a very fun group. National Museum Kan Rd given by Dr. Vinit Winitnaiyapak Year 2533 on the conservation and preservation of the current building at the central library. National Museum Kan Rd Pathum Thani iron using charcoal. To brazen casting method. Cover the top with hinged rear burner (open top side up) at the end of a bent pin, which use gravity to make a log. Will be opened by a thermal insulation knocked lightly, it will open easily. Operating time May need to add charcoal or charcoal ashes fell to the kickoff. Will be open for such. At the bottom of the oven with a grill. Tall cast iron 1 cm from the floor and the bottom edge has a small hole to allow air into the combustion me on. Use a stick to charcoal stove before. When caught, then it will fork into the oven. Cover with modest Ashes Not to be too hot (Like baking banana otherwise), so that the fabric can be easily burned. Required proficiency in the use of heat, cold enough to control the burner to suit the type of fabric to be ironed. Adjusted by the addition of ashes or charcoal to heat up knocked out. (More air), the inventor of the first electric iron (Robert Hare, an American in the year 2324), the clothes are folded flat. Strengthening the personality to look good. Electric irons, electric heating devices that facilitate in making a smooth and beautiful clothes, electric irons generally divided as follows: 1. Conventional electric iron (Electric Irons) work when an electric current flows through the plates to heat up the heating pad is passed to the iron too much to pull the plug of the iron to the surface of the iron gradually cool down, but less heat. to plug The electric current flows through the two plates again. Electric iron unattended (Automatic Electric Irons) work when an electric current flows into iron. It is through exposure to the hot wire and wire resistance, respectively, which makes heating pad, heat transfer heat. To the surface of the iron Bright and sheet - metal adhered to the iron. Was the heat of the soleplate to - metal has been heated to a bend on the amount of heat that has been the result of pressure between contacts less of the ground hot irons to the location. the contact area, it will not eliminate current to flow through the cooling plate heated iron plate BI - METAL will start straight track. Then touch it to electricity to heat plates 3 again. Steam Iron (Electric Steam Iron) Iron steam irons have evolved from the automation. The iron and smash it does not need water to a cloth mat. It will provide direct steam irons. For components and working principle of a steam iron is similar to the iron unattended. That is, a heating pad, a heating equipment, and thermostat, but in a control device Woon temperature of iron is different steam irons are equipped for the water to create steam to the fabric. Need information from board http://www.oknation.net/blog/phaen/2007/08/12/entry-1noo-ddd at 00:11
การแปล กรุณารอสักครู่..